Leak damage repair
Water damaged areas are opened and fixed so the roof is solid again.
A roofer in Clark can repair a mobile home roof by resealing open seams, replacing loose fasteners, sealing vents and the AC curb and recoating the roof so it sheds water again. One call to (908) 562-6899 reaches a nearby roofer who works on mobile homes.
A mobile home roof has its own weak points, and most leaks start at the same few spots. The roof might be metal panels, an EPDM or TPO membrane, or asphalt shingles on a pitched roof, depending on the age and model of the home. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
Small leaks spread fast in a mobile home. Ceiling panels, particleboard and fiberglass insulation soak up water, so a leak that looks minor can leave stained or sagging ceilings, soft floors near walls and mold above the ceiling. A ceiling sagging with water can be drained through a small hole into a bucket, away from any light fixture, with power to that area shut off at the panel if the panel is safe to reach.
The framing under a mobile home roof is light, so walking it takes care. Weight should go on the trusses, not between them, which is why roofers often use boards to spread their weight. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
Many mobile home roof repair calls in Clark also turn up a need for roof coating or metal roof repair.
Need mobile home roof repair in Clark? Call (908) 562-6899 to talk to a local roofer.
Call nowA lasting repair seals the roof and deals with any water damage underneath.
From a ladder and along the truss lines, the roofer checks seams, screws, coating, edges and penetrations. Inside, ceiling stains help point to where water is getting in.
Backed out fasteners are swapped for new gasketed screws, often a size up so they bite into fresh wood. Surface rust is wire brushed and primed.
Panel seams are cleaned and sealed with butyl seam tape or a reinforced seam sealer. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Old caulk is removed from vents, skylights and the AC curb, and they are resealed with a sealant compatible with the roof, or replaced if cracked. The perimeter edge where roof meets wall is sealed as well.
On metal and some membrane roofs, a full elastomeric or silicone roof coating is applied after repairs to seal small gaps and reflect sun. The roof must be clean and dry for the coating to stick.
Water damaged areas are opened and fixed so the roof is solid again.
An elastomeric or silicone coating is applied which slows rust on metal.
Vents, skylights and the AC curb are resealed or new flashing where needed.
Loose and rusted screws are replaced with gasketed fasteners so the roof stops rumbling.
Open seams are sealed with tape or fabric and coating so water stops getting through.
Mobile home roof replacement makes sense when the metal has rusted through in many places, the membrane is worn out or the decking and trusses have rotted from years of leaks. Replacement may include new sheathing over the trusses, fresh insulation and a new roof of metal, rubber membrane or TPO. Damaged trusses are fixed first.
In Clark, mobile home roof replacement plans begin with the data plate and the condition of the trusses. Ask whether a permit is needed, since manufactured homes can have their own rules. The goal is a roof that sheds water and stays quiet in the wind for years.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. Options include a framed pitched roof that adds an attic space, an insulated membrane roof over, or new metal fastened over furring strips. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
A mobile home roof over in Clark has to fit the structure of the home, so the added weight and how the new roof attaches are checked first. Pitched roof overs in particular may need engineering and a permit, and they should be anchored to resist wind uplift. A good roof over ends the seam and screw leaks that plague old metal roofs.
Mobile and manufactured homes in Clark range from older single and double wides with metal roofs to newer homes with pitched shingle roofs. For homes in Clark and nearby towns like Rahway, Colonia, Garwood and Cranford, resealing and recoating every several years keeps most metal roofs dry, and catching a leak early keeps ceiling panels and framing from rotting.
For mobile home roof repair in Clark, NJ or nearby towns like Rahway, Colonia, Garwood and Cranford, call (908) 562-6899 to reach a roofer who covers your street.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Clark is busiest after a hard winter and before the next one.
Small roof problems caught early usually stay small repairs.
Local roofers see the same roofs and storm damage across Clark and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (908) 562-6899
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, when the roof underneath is still dry and solid.
Learn moreRepairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, so the panels keep shedding water for years more.
Learn moreRepairs for leaking rubber roofs, from peeling seams to pulled flashing at walls and curbs, after the real leak point is found.
Learn moreFinding where water gets through the roof and sealing it at the source, before wet decking and insulation turn into rot.
Learn moreLooking for something else?
See all roofing servicesCall now for Clark mobile home roof repair and help in the towns around it.